|
Title: What kind of bead pattern should be avoided when welding stainless steel with FCAW equipment? Post by: roddyrodrod on Feb 23, 2018 What kind of bead pattern should be avoided when welding stainless steel with FCAW equipment?
a. Downhill b. Weave c. Stringer d. Fillet [Ques. 2] To control the amount of metal buildup when performing flat fillet welds with FCAW, the welder should _____. a. cool the practice coupon in water b. clean the weld with solvent c. increase or decrease the travel speed d. run the root pass with a 90-degree work angle [Ques. 3] The distance that a weld extends above a line drawn between the toes of the weld is called _____. a. weld axis b. convexity c. undercut d. overlap [Ques. 4] One of the criteria for an acceptable overhead V-groove weld done with stringer beads is that the bead width must be uniform within _____. a. 1/16 (1.6 mm) b. 1/8 (3.2 mm) c. 3/8 (9.5 mm) d. 1/2 (12.7 mm) [Ques. 5] When making vertical FCAW V-groove welds with weave beads, which weave pattern should be used? a. Zigzag b. Circular c. Square-shaped d. Crescent-shaped Title: What kind of bead pattern should be avoided when welding stainless steel with FCAW equipment? Post by: THOTLESLEY on Feb 23, 2018 Content hidden
Title: What kind of bead pattern should be avoided when welding stainless steel with FCAW equipment? Post by: roddyrodrod on Feb 23, 2018 Thank you for your assistance, again and again
Title: What kind of bead pattern should be avoided when welding stainless steel with FCAW equipment? Post by: THOTLESLEY on Feb 23, 2018 My pleasure
|