Quickly gain a reputation by helping other students with their questions. When students see your nickname, they'll immediately associate your answer with credibility and expertise. Also, earn credits for sharing your knowledge and redeem them for rewards.
Hysteresis is the difference of the two readings (increasing and decreasing trends) of the same pressure. You can divide the difference by the average of the 2 readings to show the hysteresis as fraction of the pressure at a particular point. As a result, at each pressure you would have a value to the hysteresis. The average of all hysteresis values would be
Do private charter planes & Jets owned require a mandatory three digit or four digit flight number with a flight naming convention similar to Commercial airlines carriers following IATA or ICAO rules & regulations?
Briefly explain the following giving relevant questions, if necessary. The answers for this questio
briefly explain the following giving relevant questions, if necessary. The answers for this question should not be more than 1 1/2 pages in length.
sensitivity and selectivity Explain the following: i) calibration sensitivity ii) analytical sensitivity iii) selectivity iv) the difference(s) between selectivity and sensitivity
Onsider a single crystal of silver oriented such that a tensile stress is applied long a [001] ...
Consider a single crystal of silver oriented such that a tensile stress is applied long a [001] direction. If slip occurs on a (111) plane and in a [101] direction, and is initiated at an applied tensile stress of 1.1MPa (160psi), compute the critical resolved shear stress.
Moisture from a noncondensable gas at T1 and P1 needs to be removed by ...
Moisture from a noncondensable gas at T1 and P1 needs to be removed by compression and then cooling so that the gas will finally contain no more than 0.5% moisture (%v). The compression and cooling costs (in $) are C1 and C2, respectively. Assume that in gas compression, gas temperature increase following the expression of ∆T= α (∆P)β
