× Didn't find what you were looking for? Ask a question
Top Posters
Since Sunday
a
5
k
5
c
5
B
5
l
5
C
4
s
4
a
4
t
4
i
4
r
4
r
4
Home Q & A Board Other Fields Homework Help Trades and Apprenticeship
New Topic  
hanbell795 hanbell795
wrote...
Go to Answer
Posts: 559
Rep: 0 0
6 years ago
Conventional alignment is also called ________ alignment.
 
  A) center line B) collinear C) rim-and-face D) horizontal


[Ques. 2] Preliminary alignment of equipment is completed prior to adding grout to the base, and is inspected again ________.
 
  A) before the grout has a chance to dry
  B) after the grout has been applied and cured
  C) only if problems show up
  D) after concrete has been applied and had a chance to shrink


[Ques. 3] To take angularity and offset measurements at the same time, set up two dial indicators ________.
 
  A) with one on each face of the coupling halves
  B) on both the face and the OD of the MTBM coupling half
  C) on both the face and the OD of the STAT coupling half
  D) with one on each OD of the coupling halves


[Ques. 4] When the coupling half must be lowered to correct vertical offset misalignment, shims are placed under the ________ of the MTBM.
 
  A) nearest end of the base plate B) rear lugs
  C) front lugs D) farthest end of the base plate


[Ques. 5] OD misalignment is also called ________ misalignment.
 
  A) rim B) parallel C) face D) jig
Read 445 times
2 Replies
Replies
Answer verified by a subject expert
pavbapavba
wrote...
#1
Posts: 307
Rep: 2 0
6 years ago
Sign in or Sign up in seconds to unlock everything for free
1

Related Topics

hanbell795 Author
wrote...
#2
6 years ago
Great answer!
New Topic      
Quick Reply
Explore
Post your homework questions and get free online help from our incredible volunteers
  1041 People Browsing
Start New Topic Take the Tour CoursesNew Study Tools Topics Trending Browse by Textbook
Live Chat
Related Images
  
 67
  
 242
  
 206