2. If the driven gear has 48 teeth and the drive gear has 12 teeth, the gear ratio is
A. 4.5:1.
B. 4:1.
C. 2.4:1.
D. 3:1.
3. The pressure plate in a clutch assembly is bolted to and rotates with the
A. pivot ring.
B. driven member.
C. flywheel.
D. release bearing.
5. Which of the following represents the number of turns of the input gear to one turn of the output gear?
A. Gear timing
B. Torque
C. Gear ratio
D. Speed
8. During clutch installation, which of the following tools is least likely used to align the clutch disc to the pilot bearing?
A. Plastic dummy transmission shaft
B. Old transmission shaft
C. Large screwdriver
D. Clutch disc alignment tool
9. Two technicians are discussing four-speed transaxles. Technician A says that the differential pinion gears turn on the differential pinion shaft when the car is going straight. Technician B says that the axle gears rotate at the same speed as the differential case. Which technician is correct?
A. Neither Technician A nor Technician B
B. Technician B only
C. Technician A only
D. Both Technician A and Technician B
12. Technician A says that a tool should be used to align the clutch disc during installation. Technician B says that before the transmission is removed, the battery should be charged and connected in order to retain any clutch related DTCs. Which technician is correct?
A. Both Technician A and Technician B
B. Technician A only
C. Technician B only
D. Neither Technician A nor Technician B
13. What type of gear has its teeth cut at an angle to the axis of the gear?
A. Amboid
B. Helical
C. Hypoid
D. Spur
14. The amount of torque that a clutch can transmit is determined by all of the following except the
A. strength of the pressure plate springs.
B. diameter of the disc.
C. master cylinder pressure.
D. number of discs.
16. Which of these is the opposite of a gear reduction condition and occurs when a driven gear turns faster than its drive gear?
A. Torque
B. Overdrive
C. Deep reduction
D. Power
18. Technician A says that engine torque is applied to the input shaft when the clutch is engaged (clutch pedal up). Technician B says that the torque capacity of a transmission is determined by the size of the gear and bearings used. Which technician is correct?
A. Neither Technician A nor Technician B
B. Technician A only
C. Both Technician A and Technician B
D. Technician B only