1. Which of the following statements is true of checking the stall speed of a vehicle?
A. The line pressure is higher in reverse and may give a more accurate engine speed.
B. The engine speed in reverse is capped so it gives a more accurate reading.
C. The clutches are less likely to slip in forward gear.
D. The line pressure is lower in reverse and may give a more accurate engine speed.
6. It's critical that the _______ be torqued in the proper sequence to avoid warpage and a possible stuck valve.
A. pump assembly
B. valve body
C. clutch pack
D. valve hoses
7. Technician A says that when a scan tool is used to command an upshift, the transmission shouldn't be in drive. Technician B says if the scan tool commands a shift to occur and a shift doesn't occur, the problem is either in the shift solenoid itself or the hydraulic system. Who is correct?
A. Technician B only
B. Both Technician A and Technician B
C. Technician A only
D. Neither Technician A nor Technician B
10. If you install an auxiliary transmission cooler, the hot fluids should travel through the
A. factory cooler, then the auxiliary cooler, then the transmission.
B. transmission, then the auxiliary cooler, then the factory cooler.
C. transmission, then the factory cooler, then the auxiliary cooler.
D. auxiliary cooler, then the factory cooler, then the transmission.
11. What should be the first item(s) checked when diagnosing an electronic shift transmission problem?
A. Wires and connectors for loose or frayed problems
B. Any diagnostic trouble codes
C. The resistance of the shift solenoids
D. The complaint and fluid level
12. The _______ often collects wear particles from clutches and bands, and therefore should be inspected carefully or replaced.
A. pump assembly
B. valve body
C. torque converter
D. separator plate
13. Which of the following parts must be replaced if it's dropped?
A. Pump
B. Pan
C. Torque converter
D. Extension housing