× Didn't find what you were looking for? Ask a question
Top Posters
Since Sunday
5
o
5
4
m
4
b
4
x
4
a
4
l
4
t
4
S
4
m
3
s
3
New Topic  
Electronica Electronica
wrote...
2 years ago
An Overview
This Lab should result in a bargraph voltmeter - it will display a representation of a sampled
voltage > 610mVdc upto 4.7 Vdc - in steps of approximately 610mV. (At ~ 4.7 V all the 8 of the
bargraph leds will be on).
Review the video ‘complete _system’ on DC Connect in the Final Project folder - to see it functioning.
- - - -
Task 1
Referring to the Nano schematic - you need to add a potentiometer, to provide • the Analog signal,
the source voltage should be +5v and a ground (refer to the Project Notes of Lab 8).
To determine the wiper pin connection point on the Nano, by referring to the Visual Design
Code of this project.
• Now refer the Visual Design code provided the other output bits that need to added the Main
LOOP function - they have already been defined in the SETUP function.
Refer to the SA function (Do Not Edit) on the second code page ‘Conversion’.
After completing the above modifications - build and test using simulation - you see the appropriate
bits change state as the potentiometer voltage changes by ~ 610mV
- - - -
Conclusion, you implemented a MCU & FPGA based voltage meter - this utilized a trim-pot and an
A-D input, your finalized code created an Led bargraph - each segment of the bargraph represents ~
610mV.

Read 201 times
1 Reply

Related Topics

Replies
wrote...
2 years ago


New Topic      
Explore
Post your homework questions and get free online help from our incredible volunteers
  1130 People Browsing
Related Images
  
 311
  
 251
  
 264
Your Opinion
Where do you get your textbooks?
Votes: 284