Top Posters
Since Sunday
5
o
5
4
m
4
b
4
x
4
a
4
l
4
t
4
S
4
m
3
s
3
New Topic  
dman1798 dman1798
wrote...
Posts: 4
Rep: 1 0
12 years ago
any help on this would be appreciated.
Read 55647 times
13 Replies
Replies
wrote...
12 years ago
Post the question Wink Face
Biology!
dman1798 Author
wrote...
12 years ago
the questions are attached. thanks again
 Attached file 
You must login or register to gain access to this attachment.
abiola,  carola92,  dhopps,  nobles,  ams0715,  robotr2d2,  shanishan,  peeps1223,  raisnj,  Ryuzaki123,  danibubblemusic,  ma0233861
wrote...
Valued Member
Educator
12 years ago
Is physo 9.0 similar to the 8.0 book if not what the different?

Questions are posed differently, could you post the questions, rather than attaching them.
dman1798 Author
wrote...
12 years ago
1.   The molecular weight of urea is approximately 60.  Which of the membranes can it pass through?
a.   50 MWCO membrane
b.   100 MWCO membrane            
c.   200 MWCO membrane
d.   Both the 100 and 200 MWCO membranes
2.   True or False:  A solution containing glucose will diffuse faster through a 200 MWCO membrane if it is heated.
3.   The molecular weight of carbon C is 12; the molecular weight of hydrogen (H) is 1; the molecular weight of oxygen (O) is 16.  The chemical formula of glucose is:  C6H12O6 .   Using some simple multiplication and addition, determine the molecular weight of one molecule of glucose.       
4.   Describe two variables that affect the rate of diffusion.
5.   Why do you think that the urea was not able to diffuse through the 20 MWCO membrane?
6.   Describe the results of the attempts to diffuse glucose and albumin through the 200 MWCO membrane.
7.   Put the following in order from smallest to largest molecular weight:  glucose, sodium chloride, albumin, and urea. 
ACTIVITY 2:  Simulated Facilitated Diffusion
8.   True or False:  The facilitated diffusion of glucose requires energy from ATP.   
9.   Which of the following might cause the facilitated diffusion of glucose from one solution to another to occur faster?
a.   Add Na+Cl- to the beaker on the left.
b.   Add K+Cl-  to the beaker on the left.         
c.   Add ATP to the beaker on the left.
d.   None of these would cause it to happen faster.
10.   True or False:   If there are a sufficient large number of transport proteins present, glucose can be transported from a solution of lower concentration to a solution of higher concentration (i.e. up its concentration gradient.)
11.   Explain one way in which facilitated diffusion is the same as simple diffusion; one way in which it is different.
12.   The larger value obtained when more glucose carriers were present corresponds to an increase in the rate of glucose transport.  Explain why the rate increased.
13.   You were asked to predict what effect you thought that adding Na+ Cl- would have on the glucose transport rate.  Why did you pick the choice you did?  How well did the results compare with your prediction?
ACTIVITY 3:  Simulating Osmotic Pressure
14.   True or False:  Osmosis is considered a type of passive transport, i.e. it does not need energy from ATP.
15.   If a cell is placed in a ________ solution of water, there will be no net movement of water in or out of the cell.
a.   hypotonic
b.   isotonic      
c.   hypertonic
16.   If you “cut” the concentration of a non-diffusible solute that is on one side of a membrane in half, the osmotic pressure will
a.   double.
b.   not change.               
c.   be half of what it was before.
17.   Explain the effect that increasing the Na+Cl- concentration had on osmotic pressure and why it has this effect.
18.   Describe one way in which osmosis is similar to simple diffusion; describe one way in which it is different.
19.   Solutes are sometimes measured in milliosmoles.  Explain this statement: “Water chases milliosmoles.”
20.   The conditions were 9mM albumin in the left beaker and 10mM glucose in the right beaker with the 200 MWCO membrane in place.  Explain the results.
ACTIVITY 4:  Simulating Filtration
21.   The filtration rate of Na+Cl- in the simulation was dependent on
a.   the pore size of the membrane.
b.   the hydrostatic pressure applied to the top beaker.   
c.   the concentration of the solutes in the lower beaker.
d.   both the pore size and the hydrostatic pressure applied.
22.   True or False:  The simulation would not function if the top beaker were open to the atmosphere instead of having pressure applied to the top beaker.     
23.   Explain in your own words why increasing the pore size increased the filtration rate.  Use an analogy to support your statement.
24.   Which solute did not appear in the filtrate using any of the membranes?
25.   Why did increasing the filtration pressure increase the filtration rate but not the concentration of solutes?
ACTIVITY 5:  Simulating Active Transport
26.   In this simulation, each of the following was (were) required In order for active transport to occur:
a.   sodium ions (Na+)
b.   potassium ions (K+)            
c.   energy from ATP
d.   All of the above were required.
27.   True or False:  The amount of ATP that you dispensed did not affect the rate that the solutes passed from one beaker to the other.   
28.   Which of the following processes require ATP?
a.   Simple diffusion
b.   Facilitated diffusion      
c.   Filtration
d.   Osmosis
e.   Active transport
29.   Describe the significance of using 9mM sodium chloride inside the cell and 6mM potassium chloride outside the cell.
30.   Explain why there was no sodium transport even though ATP was present.
31.   Explain why the addition of glucose carriers either had no effect or did have an effect on sodium or potassium transport.
32.   Do you think glucose is being actively transported or transported by facilitated diffusion in this experiment.  Why?
raisnj
wrote...
Staff Member
12 years ago
Can't answer them all, but I think these are the answers you're looking for Thinking Face

1.   The molecular weight of urea is approximately 60.  Which of the membranes can it pass through?
a.   50 MWCO membrane
b.   100 MWCO membrane            
c.   200 MWCO membrane
d.   Both the 100 and 200 MWCO membranes
2.   True or False:  A solution containing glucose will diffuse faster through a 200 MWCO membrane if it is heated.
3.   The molecular weight of carbon C is 12; the molecular weight of hydrogen (H) is 1; the molecular weight of oxygen (O) is 16.  The chemical formula of glucose is:  C6H12O6 .   Using some simple multiplication and addition, determine the molecular weight of one molecule of glucose.       
4.   Describe two variables that affect the rate of diffusion.
5.   Why do you think that the urea was not able to diffuse through the 20 MWCO membrane?
6.   Describe the results of the attempts to diffuse glucose and albumin through the 200 MWCO membrane.
7.   Put the following in order from smallest to largest molecular weight:  glucose, sodium chloride, albumin, and urea. 
ACTIVITY 2:  Simulated Facilitated Diffusion
8.   True or False:  The facilitated diffusion of glucose requires energy from ATP.   
9.   Which of the following might cause the facilitated diffusion of glucose from one solution to another to occur faster?
a.   Add Na+Cl- to the beaker on the left.
b.   Add K+Cl-  to the beaker on the left.         
c.   Add ATP to the beaker on the left.
d.   None of these would cause it to happen faster.
10.   True or False:   If there are a sufficient large number of transport proteins present, glucose can be transported from a solution of lower concentration to a solution of higher concentration (i.e. up its concentration gradient.)
11.   Explain one way in which facilitated diffusion is the same as simple diffusion; one way in which it is different.
12.   The larger value obtained when more glucose carriers were present corresponds to an increase in the rate of glucose transport.  Explain why the rate increased.
13.   You were asked to predict what effect you thought that adding Na+ Cl- would have on the glucose transport rate.  Why did you pick the choice you did?  How well did the results compare with your prediction?
ACTIVITY 3:  Simulating Osmotic Pressure
14.   True or False:  Osmosis is considered a type of passive transport, i.e. it does not need energy from ATP.
15.   If a cell is placed in a ________ solution of water, there will be no net movement of water in or out of the cell.
a.   hypotonic
b.   isotonic      
c.   hypertonic
16.   If you “cut” the concentration of a non-diffusible solute that is on one side of a membrane in half, the osmotic pressure will
a.   double.
b.   not change.               
c.   be half of what it was before.
17.   Explain the effect that increasing the Na+Cl- concentration had on osmotic pressure and why it has this effect.
18.   Describe one way in which osmosis is similar to simple diffusion; describe one way in which it is different.
19.   Solutes are sometimes measured in milliosmoles.  Explain this statement: “Water chases milliosmoles.”
20.   The conditions were 9mM albumin in the left beaker and 10mM glucose in the right beaker with the 200 MWCO membrane in place.  Explain the results.
ACTIVITY 4:  Simulating Filtration
21.   The filtration rate of Na+Cl- in the simulation was dependent on
a.   the pore size of the membrane.
b.   the hydrostatic pressure applied to the top beaker.   
c.   the concentration of the solutes in the lower beaker.
d.   both the pore size and the hydrostatic pressure applied.
22.   True or False:  The simulation would not function if the top beaker were open to the atmosphere instead of having pressure applied to the top beaker.     
23.   Explain in your own words why increasing the pore size increased the filtration rate.  Use an analogy to support your statement.
24.   Which solute did not appear in the filtrate using any of the membranes?
25.   Why did increasing the filtration pressure increase the filtration rate but not the concentration of solutes?
ACTIVITY 5:  Simulating Active Transport
26.   In this simulation, each of the following was (were) required In order for active transport to occur:
a.   sodium ions (Na+)
b.   potassium ions (K+)            
c.   energy from ATP
d.   All of the above were required.
27.   True or False:  The amount of ATP that you dispensed did not affect the rate that the solutes passed from one beaker to the other.   
28.   Which of the following processes require ATP?
a.   Simple diffusion
b.   Facilitated diffusion      
c.   Filtration
d.   Osmosis
e.   Active transport
29.   Describe the significance of using 9mM sodium chloride inside the cell and 6mM potassium chloride outside the cell.
30.   Explain why there was no sodium transport even though ATP was present.
31.   Explain why the addition of glucose carriers either had no effect or did have an effect on sodium or potassium transport.
32.   Do you think glucose is being actively transported or transported by facilitated diffusion in this experiment.  Why?


Activity 1: Observing Diffusion of Dye Through Agar Gel (p. 55)

6. Potassium permanganate (MW 158) diffused more rapidly than methylene blue (MW 320). The smaller the molecular weight, the faster the rate of diffusion. The dye molecules moved because they possess kinetic energy.

Activity 2: Observing Diffusion of Dye Through Water (p. 56)

4. Potassium permanganate diffuses more rapidly through the water. Although the agar gel is largely water, it does contain more solid particles, which hinder free diffusion.

Activity 3: Observing Diffusion Through Nonliving Membranes (pp. 56–57)

5. After 1 hour, sac 1 (originally containing 40% glucose) should have gained weight. Water is moving into the sac by osmosis. Glucose is still present in the sac, and a small amount of glucose may also be present in the beaker. If the Benedict’s test is positive, glucose was able to pass through the dialysis membrane.
- Master of Science in Biology
- Bachelor of Science
wrote...
Valued Member
Educator
12 years ago
Did this solve your question?
wrote...
12 years ago
answer to #1 is d.  #2 true
Answer verified by a subject expert
MEKAYLAMEKAYLA
wrote...
Posts: 27
Rep: 4 0
12 years ago
Sign in or Sign up in seconds to unlock everything for free
This verified answer contains over 3000 words.
gurungpd

Related Topics

wrote...
12 years ago
the questions are attached. thanks again

Thank you very much!
wrote...
11 years ago
here are my answers
 Attached file 
You must login or register to gain access to this attachment.
colleen,  taniachapa95,  katiedrew50,  143_SJ,  spen,  shinwaaka,  jojobasheabutte,  aznulzzang,  panda3
wrote...
11 years ago
Awesome! Thanks!
wrote...
11 years ago
Hope this helps - it's the first activity
 Attached file 
(24.83 KB)
You must login or register to gain access to this attachment.
hilroy,  phantomvox,  Mell73
wrote...
11 years ago
Super helpful Wink Face
New Topic      
Explore
Post your homework questions and get free online help from our incredible volunteers
  971 People Browsing
 110 Signed Up Today
Related Images
  
 27
  
 800
  
 262
Your Opinion
Which industry do you think artificial intelligence (AI) will impact the most?
Votes: 308