To set a dial indicator's freedom of movement ________.
A) press in the plunger until the indicator's needle completes two full turns
B) zero the dial indicator
C) move the plunger to see one half turn in each direction
D) press in the plunger until the indicator's needle completes one full turn
[Ques. 2] Lasers are classified according to their ________.
A) source B) application C) range D) intensity
[Ques. 3] When aligning machinery, it's important to realize that alignment refers to the ________.
A) positions of the two center lines of rotation B) coupling center
C) position of the machine center line D) coupling point
[Ques. 4] When using graphical alignment, the ________ are recorded vertically and the ________ are recorded horizontally.
A) STAT readings; MTBM measurements B) indicator readings; distance measurements
C) distance measurements; indicator readings D) MTBM measurements; STAT readings
[Ques. 5] Whether using chart alignment or mathematical formulas to calculate corrective movement or shim thickness, ________.
A) it is not necessary to measure the distance from feet to couplings
B) it is not necessary to measure preciselyestimations are used in these calculations
C) read every dial indicator position at least twice and measure and note indicator sag
D) the calculations will work out the same, whether values are recorded as negative or positive