Doubled top plates are required in SIP construction. The end joints in top plates must be offset by ...

Doubled top plates are required in SIP construction. The end joints in top plates must be offset by a minimum of ________ inches.
 
  A) 6 B) 18 C) 12 D) 24

---

[Ques. 2] The ________ method of cutting lumber is the least expensive and most commonly used for residential rough framing.
 
  A) Dimensional B) Plainsawn C) Quartersawn D) Nominal

---

[Ques. 3] Information on basement walls, piers, and footings can be found on the ________ plan(s).
 
  A) Floor B) Site C) Exterior D) Foundation

---

[Ques. 4] The oldest known plan dates back to around what year?
 
  A) 2100 BC B) 3600 BC C) 1492 AD D) 1066 AD

---

[Ques. 5] The construction procedure for panel assembly of SIPs should always start ________.
 
  A) In one direction  from left to right B) Prior to placement on the subflooring
  C) In the middle of a through-wall D) In a corner