Technician A says most engine flywheels are lightweight to avoid causing inertia. Technician B says most engine flywheels are made of hardened forged steel to absorb the heat of clutch operation. Which technician is correct? A) Technician A only B) Technician B only C) Both technicians D) Neither technician
|
|
The steering shaft torque sensor uses ________ as inputs to the EPS control module A) Calibrated springs B) Vacuum pulses C) Voltage signals D) Viscous resistances
|
|
Which tier of emission standards became fully effective in 2009? A) Tier 3 B) Tier 2 C) Tier 1 D) None of these
|
|
All these are causes of catalytic converter failure EXCEPT ________. A) Contamination B) Incorrect air/ fuel mixture C) Excessive temperature D) All of these are causes of converter failure.
|
|
Which of these should never be used as windshield washer fluid? A) 20 % Washer fluid and 80% water mixture B) 50 % Washer fluid and 50% water mixture C) Pure water D) Ethylene Glycol
|
Answer
Click to Reveal
Can't thank you enough
|
How much current flows through the alternator brushes? A) 2-5 B) 25 to 35 A, depending on the vehicle C) All of the alternator output flows through the brushes D) 10 to 15 A
|
|
Use of the wrong type of RTV silicone sealer could damage the ________. A) Crankshaft sensor B) Water pump C) Oxygen sensor D) Water pump gasket
|
|